The NCS-C150 is a two (2) radio repeater for cross band or in-bandoperation. (In-band operation requires the same RF proximity andAntenna considerations as any other in-band repeater). This flexible unit works withconventional, trunked and P25 radio systems. Rapid deployment, simple configuration, easyoperation and no training required make this an ideal solution for occasional deployment inmutual aid situations as well as day-to-day interoperability operations. The unit contains anautomatic gain control circiut so setting of each radio´s receive audio is not required. Eitherradio can use COR of either polarity or VOX for the Busy signal. Interface cables areavailable for nearly any radio including PTT phones. The NCS-C150 has a small form factorof approx 4 x 4.75 x 1.25 inches and operates from 9-14VDC for use in any vehicle or fixedlocation.

Internal Settings

The NCS-150 has internal settings for operating mode selection:

COR+ High going carrier detect signal from radio.
COR- Low going carrier detect signal from radio.
VOX Received signal detection from voice signals being received.
LOW-HANG Reduces the hang time when in VOX Mode.
TX level controls are also provided as well as a REC level control for recording of combines audio.

Accessories

Radio Cables. NCS provides cabling to interface most commercial and amateur radios with the NCS-C250. Cables can be provided for mobile as well as portable radios. The cables come in a standard length of 6 feet, however custom lengths are available.
Audio & PTT Delay Module The C410 Delay Module provides a user selectable audio delay to accommodate inherent delays seen in trunked systems between receipt of PTT and assignment of channel. Delays of 0, 50, 100, 200, 400, 800, 1600 & 3200msec are selectable.
AC Power Supply A variety of power supplies are available for use with the C150.